WAGO 8FDI 24V PROFIsafe 750-662/000-004 Manual page 98

98 Service
• Before an update via the service interface, disconnect the fieldbus cable
from the fieldbus coupler/controller.
• Do not close the software during the update.
• Only run the software from a local hard disk.
Additional Information from WAGO Support!
Additional information about the software "WAGO I/O-Update 750" is available
through WAGO Support.
Manual
Version 1.0.0, valid from HW/SW Version 01/01
WAGO I/O System
750-662/000-004 8FDI 24V PROFIsafe