Writing Iparameters To The Module Or Parameter File - WAGO 750 Manual

56 Commissioning
Another iParameter Set Description dialog opens. In this dialog, check the
information concerning the project, changes made and persons responsible and
change the information if necessary. Click [OK] to confirm the information
entered.
7.3.1.2

Writing iParameters to the Module or Parameter File

In the Input column of the iParameter set table, you can make the desired
changes to the iParameter values.
After selecting an iParameter, you can select the iParameter values from a
selection field or enter them directly.
If an iParameter value is changed, it is marked with a pencil icon that appears in
the first column of the iParameter set table. Invalid values are marked in red and
must be modified.
After changing the iParameter values, transfer them into the F I/O module. To do
so, click the [Write] button in the WAGO Safety Editor toolbar.
If you have assigned a password for the F I/O module, you are then asked to
enter it. After the password is entered, the parameter values are transferred and
verified by the F I/O module.
The F I/O module performs an internal check of the transferred iParameter
values. If the iParameter verification fails, an error message is output.
The verified iParameter values are then read out of the F I/O module and
displayed in the Verification column of the iParameter set table of WAGO Safety
Editor.
Now compare the iParameter values of the Input column to the values of the
Verification column row by row. If the values are identical, mark the row as
verified by checking the box to the right of the Verification column.
Once all rows have been verified (all boxes are checked), the box in the column
header is checked automatically.
Now save the new iParameter values permanently in the F I/O module by clicking
the [Save] button in the WAGO Safety Editor toolbar.
The F I/O module now permanently stores the iParameter values in the F I/O
module. The values are then read out once again and displayed in the Input
column of the iParameter set table for another check.
If all settings are correct, save the iParameter set in a parameter file. Click the
[Save] button in the WAGO Safety Editor toolbar to save the iParameter set.
The iParameter Set Description dialog opens for a more detailed description of
the parameter file. In this dialog, enter information about the project, the changes
made and the persons responsible. Click [OK] to confirm the information entered.
Manual
Version 1.0.0, valid from HW/SW Version 01/01
WAGO I/O System 750
753-661/000-004 4FDI 24V PROFIsafe