WAGO 750 Manual page 88

88 Diagnostics
Table 36: Diagnostic Messages
Message
Error
downloading
iParameters
Error uploading
iParameters
F_Dest_Add
mismatch
F_WD_Time
expired
Manual
Version 1.0.0, valid from HW/SW Version 01/01
Diagnostic type Module diagnostic
Coding 0x004A
LED indicator No indicator
Description/ Timeout when writing (downloading) the
remedy iParameters from the iPar server. Check
whether an iPar server instance was
created for the F I/O module and whether
an appropriate data set exists.
Classification Error
Diagnostic type Module diagnostic
Coding 0x0049
LED indicator No indicator
Description/
Timeout when saving (uploading) the
remedy iParameters to the iPar server. Check
whether an iPar server instance was
created for the F I/O module.
Classification Error
Diagnostic type Module diagnostic
Coding 0x0040
LED indicator
Module error: red
PROFIsafe status: red
Description/ The PROFIsafe address assigned as part
remedy of the F parameterization differs from the
one set on the F I/O module. Check the
DIP switch setting or PROFIsafe address
set using the safety editor (SEDI).
Classification Error
Diagnostic type Module diagnostic
Coding 0x004E
LED indicator Module error: red
PROFIsafe status: red, flashing at 1 Hz
Description/ The time between two data packets from
remedy the safe PLC was greater than the time set
in F_WD_Time. Check the F_WD_Time
parameter and increase the value if
necessary.
Classification Error
WAGO I/O System 750
753-661/000-004 4FDI 24V PROFIsafe
Description