Setting Daytime Mode - Teletek electronics iRIS8 Engineer Programming Manual

4.3. Setting Daytime Mode

This is a menu for setting time day time mode for operation of the panel. In Day mode the detectors operate with alarm
level which has been programmed as day mode. This is usually a level of lower sensitivity. It lowers the risk of false
alarms caused by dust, cigarette smoke, etc. Night time mode is opposite to the daytime mode (higher level of
sensitivity is applied). The Night mode is Enables, when the Day Time mode is set to OFF
Enter MAINTENANCE – DAY MODE menu.
By default, the Day Time Mode is set to OFF. To change
the operation mode, press the button with respective
setting.
The time schedule table presents the preprogrammed
hours for turning ON and turning OFF the day time
activation mode. The times are set for every day of the
week.
To set a time for ON/OFF, press the button corresponding
of the day of the week.
Use EXIT button to return back to Maintenance Menus.
iRIS8 - Addressable Fire Alarm Panel – Installer Programming
The Day Time operation mode is Enabled, when the
button is selected and inactive (grey color with black text):
• OFF – The Day Time mode is constantly turned OFF.
The icon on status bar is "moon" (
• ON – The Day Time mode is constantly turned ON.
The icon on status bar is "sun" (
• Time Schedule – Programming of a schedule list for
all week days for using day time mode. The button is
always active, regardless it is selected or not.
Press APPLY button to confirm the set configuration.
In the example: the day time activation mode will be
turned ON via set time schedule.
The TIME SCHEDULE is set after pressing the button
next to Day mode field.
Use the arrows, or directly set the time via digit button
and virtual keyboard. Confirm the set time with APPLY
button. The panel will return to Time Schedule settings
screen as the new time is directly set for the respective
day of the week.
67
).
).