Change Address; Start Self Addressing - Teletek electronics iRIS8 Engineer Programming Manual

iRIS8 - Addressable Fire Alarm Panel – Installer Programming

3.2.9.2. Change Address

In this submenu the installer can change the address number of a device. To change address of a device, enter in the
installer's menu - ADDRESSING - CHANGE ADDRESS.
The system automatically shows the first address in the
system. If the address is assigned, the panel will display
the device with its system name. You can check the
position of the device assigned at this address with
pressing the TURN ON button - the device LED(s) will light
on permanently. Next pressing of the same button will off
the LED(s).
During the changing of the address, the system is idle for
operation. The blinking system icon shows that the
process is running on.
Note: You can change the addresses only of devices
connected to one and the same loop number.

3.2.9.3. Start Self Addressing

In this submenu the installer can perform self-addressing procedure of devices to the system configuration. The self-
addressing procedure is suitable when there is great number of new devices to be connected to the panel.
The new devices are prepared for connection to the system configuration - the loop line is ready but the devices are not
installed (the detectors and sounders are not mounted to the bases; the call points and modules are not connected to
the loop).
To perform self-addressing, enter in the installer's menu - ADDRESSING - START SELF ADDRESSING. The panel
shows the first free address for every of the IRIS TTE loops. Now the installer can start mounting detectors and modules
one by-one. The panel will set the displayed address number to the mounted device and automatically proceeds with
next free address in the system.
The self-addressing menu shows information about the total number of devices connected to every loop.
In the NEXT ADDRESS field, the panel shows the first free address for every of the loops. The panel skips all already
set address numbers and will jump to the next free address number. You can scroll over the address number using the
arrows or directly enter a digit via the virtual keypad.
In self-addressing mode the panel waits for connecting the device to the loop, automatically sets the current address to
the device and moves to the next free address number. With every one added device to the system configuration the
address count will increase to show the total number of devices connected to the respective loop.
Press EXIT button to stop the process and to exit the menu.
Use the arrow buttons to select the address and loop
number of the device you want to change. In the field
NEW ADDRESS, set the new address number for the
device. If the address is FREE for use, the APPLY button
will appear on the left bottom on the screen.
If the changing of the address is successful, the message
SUCCESSFUL is shown on the screen. The panel enters
in reset mode. You can proceed with changing other
address or escape with EXIT button.
38