Zones - Quick Review; Devices - Teletek electronics iRIS8 Engineer Programming Manual

iRIS8 - Addressable Fire Alarm Panel – Installer Programming
To exit from the ZONES submenu press EXIT button.
3.1.5. Zones – Quick Review
Next to ZONES menu is situated button << GRID VIEW for quick reviewing the operation status of all zones. The zones
are reviewed at several screens, as 60 numbers are displayed at the same time.
First are displayed the zone numbers from 1 to 60.
The Enabled zone numbers are presented with active
button in blue. The Disabled zone numbers are presented
with active button in white.
For quick access to a zone setting menu, press its
number. To go back from zone menu to grid view menu,
press EXIT button.
To exit from the << GRID VIEW menu press EXIT button.

3.2. Devices

Enter DEVICES menu. The menu includes submenus for settings and programming of periphery and loop devices, as
the ways for addressing of loop devices.
It is recommended to arrange the Sounder Groups
and to associate the sounders to the respective
zone numbers in advance.
Zone Sounder
No Group
1 1
2 2
3 3
The used numbers for Sounder Groups and Zones
in the example are illustrative. It is not required the
numbers for Sounder Groups and Zones to match.
This approach is used to make the presented
example clearer.
To review the zone numbers from 61 to 120, press down
arrow button. Press button again to review zones from
121 to 180, etc. Press the up arrow button to move back.
Every change of the operation status of the zones is
updated immediately in the Grid View menu.
Quick summery for the submenus:
- Settings for Loop Devices (item 3.2.6)
- Quick review of the loop devices' status by
address number (item 3.2.7)
- Addressing of loop devices (item 3.2.9)
- Settings for Periphery Devices (item 3.2.1)
16
Panel Settings
Sounder
(Sounder GROUP
No
menu)
GROUP A: 2
SND 1 GROUP B: 3
GROUP C: 0
SND 2 GROUP A: 1
SND 3 GROUP B: 3
SND 4 GROUP C: 0
SND 5 GROUP A: 1
SND 6 GROUP B: 2
SND 7 GROUP C: 0