Loop Devices - Quick Review - Teletek electronics iRIS8 Engineer Programming Manual

iRIS8 - Addressable Fire Alarm Panel – Installer Programming
Every loop device can be removed from the system configuration, regardless of its current operation mode. Press
REMOVE button. The removing is immediate without need of confirmation.
TURN ON/OFF is a special button implemented in the setup menus of the SensoIRIS addressable devices:
Press EXIT button to return to main menu DEVICES.
3.2.7. Loop Devices – Quick Review
Next to LOOP menu is situated button << GRID VIEW for quick reviewing the operation status of all loop devices. The
devices are reviewed at several screens, as 50 address numbers are displayed at the same time. The devices can be
reviewed also loop by loop.
First, the device address numbers from 1 to 50 are
displayed. The loop number can be changed on the top of
the screen. Press the active digit button next to loop filed.
To review the device address numbers from 51 to 100, press down arrow button. Press button again to review
addresses from 101 to 150, etc. Press the up arrow button to move back.
The operation and system status of the loop devices is presented with color buttons and address number for easy
recognition:
•
Enabled device - active blue button.
•
Disabled device - active dark grey button.
•
Device in Fault - active yellow button.
•
Free Address (N/A) - inactive light grey button.
For quick access to a device address setting menu, press its number. To go back from loop device menu to grid view
menu, press EXIT button.
Every change of the operation or system status of a loop device is updated immediately in the Grid View menu.
To exit from the << GRID VIEW for loop devices menu, press EXIT button.
Note: If after deleting, the removed device is still
connected physically to the loop, the panel will find it and
will alert with "
New Loop Devices Found
avoid this, it is recommended first to disconnect the
device from the loop and after that to remove it from loop
devices menu.
The button turns on the LEDs (or sound signalization for
WSOU, WSOU IS, BSOU and BSOU IS) of the device
when checking its place of installation.
When the state is ON the LED of the device is lighting on
(sounders WSOU, WSOU IS, BSOU and BSOU IS are
activated). After exiting the device menu, the button
automatically switches into OFF state and the LED lights
off.
Note that the devices MINP M, WSOU, WSOU IS, BSOU
and BSOU IS have no LED indication.
Press a number of a loop to review the status of the
connected devices. The screen moves automatically back
showing the grid view with device addresses.
22
" fault messages. To