Event Type Output; Edit Outputs Map - Menu For Setting Input Groups, Controlling Outputs - Teletek electronics iRIS8 Engineer Programming Manual

iRIS8 - Addressable Fire Alarm Panel – Installer Programming

3.4.5. Event Type Output

Select this type, when in case of activation of input logic, the output has to perform a general event. Press MORE button
to access the list with general events. All introduced changes must be confirmed with APPLY button.
Press the active button for the respective action event.
The selected action event is automatically set into the
FUNCTION section.

3.4.6. Edit Outputs MAP - Menu for setting input groups, controlling outputs

This is a special menu for programming logic operations for activation of outputs. The map is individual and can be set
for every output number. The logical interactions of how inputs will control the output are set on a map, as it is
presented on a separate screen after pressing the Edit Outputs Map button from the Outputs main menu.
Press EDIT OUTPUTS MAP active button to program the
logic operation for activation of the loop type output (in the
example above).
The possible general events for activation of the output
are listed after pressing the active button for FUNCTION
selection:
- ALARM – The output will perform an ALARM type
event, such as FIRE Alarm.
- FAULTS - The output will perform a FAULT type event.
- WARNINGS - The output will perform a WARNING type
event.
The screen is organized into 3 areas:
1 - Section for setting of input group numbers operating
into OR logic.
2 - Section for setting of input group numbers operating
into AND logic.
3 - Setting the type of logic interaction between sections 1
and 2 - AND or OR logic function. Every pressing of the
function button changes the set logic AND/OR.
The chosen logic is displayed on the screen with a
diagram representing the interaction between the input
group numbers from the sections 1 and 2.
To set an input group number, press the button and enter
the number via the keyboard. Note: It is important to know
in advance the numbers of the used input group for the
operation of the programmed output. It is recommended
to create a list describing the correspondence between
input - output logical operation.
52