Input-Output Module Screen; Loop Controller Screen - Teletek electronics iRIS8 Engineer Programming Manual

3.2.4. Input-Output Module Screen

The OUT1 input-output module has the following hardware resources:
Inputs
Relays
Monitoring Outputs
Software Revision
The OUT2 output module has the following hardware resources:
Monitoring Outputs
Software Revision

3.2.5. Loop Controller Screen

At the Loop parameters screen the installer can review the following information:
Loop
Device Type
Software Revision
Load [A]
4 Monitoring inputs: Protection Confirmation, Fault Protection, Alarm Confirmation, Fire
Protection (VdS 2540).
4 Programmable relay outputs 10A@24V DC.
4 Monitored outputs: Sounder, Fire Protection, Fire, Fault.
Software version of the input-output module.
1 Monitored output: Sounder.
Software version of the output module.
Address number of the loop in the hardware configuration of the system.
Type of the communication protocol.
Software version of the loop controller.
Current consumption in the loop.
iRIS8 - Addressable Fire Alarm Panel – Installer Programming
At ADDRESS 2 is presented information about the input-
output module (OUT1) connected to first main power
supply.
The screen displays the hardware capability of the
module – the number of available inputs and outputs.
At ADDRESS 12 is presented information about the
output module (OUT2) connected to second main power
supply.
The loop controllers always take consequent addresses
from 3 to 10. The address number is added automatically
and its number depends on the hardware configuration of
the panel.
19