Section For Events Review; Functional Buttons For Programming; Sound Signalization - Teletek electronics iRIS8 Engineer Programming Manual

iRIS8 - Addressable Fire Alarm Panel – Installer Programming

1.3.5. Section for Events Review

The messages for events are displayed on the screen according their priority for indication. They can be reviewed at
any time with no matter of the set Access level. According the type of the event, is activated and the corresponding LED
indication for system status – see item 1.3.1, and activated zone number – see item 1.3.2.
Refer to "User Operation & Maintenance Programming Manual for iRIS8" for details about reviewing of system events
list.

1.3.6. Functional Buttons for Programming

Button
Entry into Installer's menus for Programming and Maintenance.
Confirmation and saving of the entered parameters. The button appears on the top left corner of
the screen after a change of settings or parameters.
Step back in programming and maintenance menus.
Cancelling the introduced changes without saving.
Enter in additional submenu with options settings. The button is inactive (grey), when no other
options are available in a menu or submenu.
Quick button for exit the programming and maintenance menus and returning back to Main Screen.

1.3.7. Sound Signalization

The iRIS8 fire alarm panel is equipped with internal buzzer for sound signalization in case of events.
Signalization
Button Single short beep indicating the pressing of a button.
Single long beep indicating reset of the panel, receiving of message for Disable, Test or Warning
Reset or Event
event, successful activation of zone in test mode.
Short beeps in case of receiving of messages for Fault event (for the panel itself or for other fire
alarm panels in the network). The beeps can be stopped for the moment, after pressing Silencing
Technical trouble Buzzer* button from the Main Screen.
The beeps will stop when the technical trouble is restored and the fault event is cleared
automatically from the Faults list.
Continuous sound for activated Fire Alarm from zone or Evacuation. The beeps can be stopped for
Fire Alarm
the moment after pressing Silencing Buzzer* button from the Main Screen.
* Note: The Buzzer Sound signalization of iRIS8 can be entirely enabled/disabled from menu SYSTEM –
PROGRAMMING – PANEL – DISABLE at Installer's Access Level 3.
Attention: The buzzer sound signalization is enabled by default. In case the internal buzzer is disabled and the main
and backup power supplies are turned off at the same time, at next power up of the panel, the internal buzzer will be
enabled automatically.
Indication – Events type
ALARMS
FAULTS
DISABLE
TESTS
WARNINGS
Description
Description
10
Priority
The highest
High
Normal
Normal
Low