Ethernet Communication; Communication Ethernet; Protocol Modbus Tcp - Siemens SICAM 7KG85X Manual

Operational Indications and Operating Parameters
13.2 Basic Functions

Ethernet Communication

13.2.4
13.2.4.1

Communication Ethernet

Table 13-8
Parameter
Communication Ethernet
21
IP address
Subnet mask 21
Default gateway
Ethernet switch on
Enable SNMP
Bus protocol
13.2.4.2

Protocol Modbus TCP

Table 13-9
Parameter
Standard port number
Access rights
User-defined port 1
22
Port number
Access rights 22
Port number
Access rights
Keep alive time
Communication supervision
time
NOTE
i
i
The 2 port numbers must be different from each other.
After the parameter changes have been enabled, the device will restart.
21
22 This parameter is available only if User-defined port 1 is set to yes.
266
Settings for Communication Ethernet
Default Setting
192.168.0.55
255.255.255.0
192.168.0.1
21
No
No
Modbus TCP
Settings for Modbus TCP
Default Setting
502
Full
No
503
Read only
504
Read only
10 s
600 (* 100 ms)
Setting Range
Any
0.0.0.0 = DHCP
Any
Any
No
Yes
No
Yes
-None-
Modbus TCP
IEC 61850
Setting Range
502
Not settable
Full
Read only
No
Yes
503 to 65 535
Full
Read only
503 to 65 535
Full
Read only
0 s = switch off
1 s to 65 535 s
0 s = none
100 ms to 6 553 400 ms
SICAM, SICAM P850/P855 7KG85X, Manual
E50417-H1040-C482-A9, Edition 03.2022