Commissioning and First Steps
9.3 Assembly
9.3
Assembly
General Assembly Notes
Depending on the model, SICAM P850/P855 is designed either for panel flush mounting (device with display)
or for DIN rail assembly (device without display).
!
WARNING
Do not touch any live parts.
Non-observance may lead to death or serious injury.
After installation of the device and wiring, close the control cabinet.
²
•
The installation site must be vibration-proof. The permitted ambient temperature must be observed (see
also chapter
•
Operating the device outside the permitted operating temperature range can lead to measuring errors
and device failure.
•
The terminals are designed for wire cross-sections of max. 2.5 mm
•
The device must not be exposed to condensation during operation.
•
Install the device in a location where it is not exposed to direct sunlight and strong temperature varia-
tions.
Assembly: Devices with Display for Panel Flush Mounting
To install the device into a switch panel, proceed as follows:
192
12 Technical
Data).
2
.
SICAM, SICAM P850/P855 7KG85X, Manual
E50417-H1040-C482-A9, Edition 03.2022