Pitney Bowes SendPro P Series User Manual page 37

Using jobs
3. Select OK. A new job tab appears. The Mail Information list is populated with the required date
correction job settings.
Note: The weighing method is not displayed in the postage correction job. Sealing mode is
set to off.
4. If necessary, change the format of the date.
5. If you are printing a tape, select the Tape button.
6. If you are printing on an envelope and if the envelope is sealed, change the sealing method to
sealer off.
a. Turn the piece of mail around 180 degrees so that the postal indicia is in the lower left
corner. Place the envelope on the feed deck with the flap facing down.
b. Select the Start button.
7. To save the job, select the Save As link at the top of the screen.
8. Enter the new job name and select OK.
Printing a postage correction
If you do not have the correct postage on a piece of mail, you can add more postage by printing a
postage correction directly on the envelope or on a tape. If you have already created a postage
correction job for the amount required, open the job and begin running mail.
1. Select the Options button at the bottom of the Run Mail screen.
2. Select Create new job... and then select Postage correction.
3. Select OK. A new job tab appears. The Mail Information list is populated with the required
postage correction job settings.
Note: The weighing method is not displayed in the postage correction job. Sealing mode is set
to off.
4. Select Additional located to the right of the envelope or tape image.
5. Type in the additional postage required and select OK.
6. If you are printing a tape, press the Tape button.
Pitney Bowes User Guide April 2022 37