Service Module Leds; Nsqm5Aiaska1/Nsqm5Aiaskb1 Ai Security Engine Module Leds - H3C SecPath M9000-AI-E8 Installation Manual

Table 6 SEM ACTIVE LED description
LED status
Steady on
Off
Card LEDs
Each SEM has the LEDs numbered the same as card slots to indicate the status of the active SEM,
standby SEM, interface switch modules, service modules, and switching fabric modules in the slots.
Table 7 and Table 8 show the LED descriptions.
Table 7 Description for the card LEDs on NSQM5SUP08A1
RUN
Flashing at 4 Hz
Flashing at 0.5
Hz
Steady on
Off
Table 8 Description for the card LEDs on NSQM5SUP16A1
LED status
Flashing green
Steady green
Steady red

Service module LEDs

NSQM5AIASKA1/NSQM5AIASKB1 AI security engine
module LEDs
The NSQM5AIASKA1/NSQM5AIASKB1 AI security engine module provides LEDs to indicate the
operation status for the module.
Table 9 NSQM5AIASKA1/NSQM5AIASKB1 AI security engine module LED description
LED
System status
LED
Description
The SEM is active.
•
The SEM is in standby status.
•
The SEM has failed. Examine the card LED for an SEM problem.
ALM Description
The card is loading software. If the LEDs keep in this state, the card
Steady on software version is not compatible with the gateway software
version.
Off The card is operating correctly.
Flashing at 0.25 The card temperature has exceeded the upper warning threshold or
Hz dropped below the lower warning threshold.
Steady on The card is in boot state or has failed.
Off The card is not present.
Description
The card is loading software.
The card has not started or is operating correctly.
The card temperature has exceeded the upper warning threshold or dropped
below the lower warning threshold.
Mark Status
Steady green
Flashing green
Flashing green and
yellow
Description
The system is operating correctly.
HDM is initializing.
A general alarm has occurred, including HDM
alarms and hardware alarms.
3