Removing The Chassis From The Rack - H3C SecPath M9000-AI-E8 Installation Manual

1. Prepare the packing bag of the cable management brackets. Make sure the bag is clean, dry,
and not damaged.
2. Use a Phillips screwdriver to loosen the screws that attach the cable management brackets to
the chassis, and then remove the cable management brackets.
3. Put the cable management brackets into the bag.
Figure 1 Removing the cable management brackets

Removing the chassis from the rack

M9000-AI gateways are heavy. If possible, use a mechanical lift to move the gateway.
To remove the chassis from the rack:
1. Prepare the wooden carton and packing bag of the chassis. Make sure the carton and bag are
clean, dry, and not damaged.
2. Remove the top cap and side panels from the wooden carton.
3. Use a Phillips screwdriver to loosen the screws that attach the mounting brackets to the rack.
4. Use at least four persons to slide the chassis outwards along the slide rails. When most part of
the chassis is removed from the slide rails, lift up the chassis by holding the handles at the
chassis sides to completely remove the chassis from the rack.
3