Installing Interface Modules Or Service Modules - H3C SecPath M9000-AI-E8 Installation Manual

Installing interface modules or service modules

CAUTION:
• The interface modules and service modules are not hot swappable. To install an interface module
or service module on the gateway, first install it on an interface switch module and then install the
interface switch module on the gateway.
• If you are not to install an interface module or service module in a slot on an interface switch
module, keep the filler panel in the slot.
The procedure is the same for installing an interface module and service module on an interface
switch module. The following installs an interface module.
To install an interface module on an interface switch module:
1. Wear an ESD wrist strap and make sure the wrist strap is reliably grounded.
2. Remove the filler panel from the target slot. Put your forefinger and thumb into the hole of the
filler panel, press the metal tab in the left hole, and then pull the filler panel out.
3. Open the ejector lever on the interface module and then push the module slowly into the slot
along the guide rails until you cannot push it any further.
4. Close the ejector lever until the latch locks the ejector lever in place.
Figure 19 Installing an interface module on an interface switch module (M9000-AI-E16
gateway)
5. Install the interface switch module in the gateway. For more information about installing the
interface switch module, see
modules."
"Installing interface switch modules or AI security engine
17