H3C SecPath M9000-AI-E8 Installation Manual page 36

Figure 17 Installing a switching fabric module for an M9000-AI-E8 gateway
Installing a switching fabric module for an M9000-AI-E16 gateway
1. Place the switching fabric module on a workbench and remove the protection box from the
connector side of the switching fabric module.
Figure 18 Removing the protection box
2. Remove the filler panel from the target switching fabric module slot. Keep the removed filler
panel secure for future use.
3. Install the switching fabric module. The installation procedure is similar for switching fabric
modules and SEMs. For more information about installing the switching fabric module, see
"Installing a SEM for an M9000-AI-E16 gateway."
16