Table of Contents
Advertisement
Figure2-8 Connect the grounding cable
Installing an M.2 SSD drive
CAUTION:
To use an M.2 SSD drive on the device, first install it on a SIC-M2-SATA riser module.
To install an M.2 SSD drive:
1.
Insert the M.2 SSD drive into the M.2 slot on the SIC-M2-SATA riser module at a 45° angle.
2.
Slightly press the M.2 SSD drive until it is level with the surface of the connector.
3.
Use a Phillips screwdriver to screw the M.2 SSD drive into place.
Figure2-9 Installing an M.2 SSD drive
Installing a SIC interface module
CAUTION:
Only the SIC-M2-SATA riser module is hot swappable. Before installing a SIC interface module
except for the SIC-M2-SATA riser module, make sure the device is powered off.
To install a SIC:
1.
Use a Phillips screwdriver to remove the fastening screws on the filler panel and remove the
filler panel.
2.
Push the SIC slowly into the slot along the guide rails until it makes close contact with the
backplane.
3.
Fasten the captive screws on the SIC.
1
2
13
3
Advertisement
Table of Contents
