Service Module Leds; Nsq1Fwcea0 Firewall Module Leds - H3C SecPath M9000 Series Manual

NOTE:
Slot numbers are marked on top of the slots on the M9010 and M9010-GM gateways and on the
right of the slots on M9006 and M9014 gateways.
Table 34 Card LED description
RUN
Flashing
Flashing
Flashing
Steady on
Steady on
Off
NOTE:
It is normal that the ALM LED for an interface module lights for a period of time at the initial phase of
the system startup.
MPU active/standby status LED
Each MPU has one ACTIVE LED to indicate the active or standby status of the MPU.
Table 35 MPU ACTIVE LED description
LED status
Steady on
Off

Service module LEDs

NSQ1FWCEA0 firewall module LEDs

The NSQ1FWCEA0 firewall module provides LEDs to indicate the operation status for the module
and its interfaces.
Table 36 NSQ1FWCEA0 LED description
LED
ALM
RUN
ALM Description
Off The card is operating correctly.
The card is loading software. If the LEDs keep in this state, the card
Steady on software version is not compatible with the gateway software
version.
The card temperature exceeds the upper warning threshold or falls
Flashing
below the lower warning threshold.
Steady on The card is in boot state or has failed.
Off The MPU is in boot state.
Off The card is not present.
Description
The MPU is active.
•
The MPU is in standby status.
•
The MPU has failed. Examine the card LED for an MPU problem.
Status
Off
Steady red
Off
Steady green
Slow flashing (1 Hz)
Description
The card is operating correctly and no alarm is generated.
A critical alarm is generated for the card. To resolve the
problem, view the system logs.
Power is not being supplied to the card or the card is faulty.
The card is operating incorrectly.
The card has booted up and is operating correctly.
61