Installing Cable Management Brackets; Installing Cable Management Brackets For An M9000-Ai-E8 Gateway; Installing Cable Management Brackets For An M9000-Ai-E16 Gateway - H3C SecPath M9000-AI-E8 Installation Manual

Installing cable management brackets

Installing cable management brackets for an M9000-AI-E8
gateway
The cable management brackets have been installed on the two sides of an M9000-AI-E8 gateway
when the gateway is shipped. You only need to attach the cable guides to the cable management
bracket.
Installing cable management brackets for an M9000-AI-E16
gateway
Install cable management brackets after you mount the gateway in the rack.
The gateway comes with three types of cable management brackets LA, LB/RB, and RA and two
types of cable guides LA and RA.
Figure 11 Cable management brackets
The installation procedure is similar for cable management brackets at the left side and at the right
side. The following installs a cable management bracket at the right side.
To install a cable management bracket:
1. If any cable guide hinders installation of the cable management bracket, press the tab on the
cable guide and then remove the cable guide from the cable management bracket.
10