H3C SecPath M9000-AI-E8 Installation Manual page 33

Installing a SEM for an M9000-AI-E8 gateway
1. Wear an ESD wrist strap and make sure the wrist strap is reliably grounded.
2. Loosen the captive screws on the filler panel and remove it from the target SEM slot.
3. Correctly orient the SEM and then push the SEM steadily into the slot along the guide rails.
4. Rotate the handle downward. Make sure the SEM makes close contact with the backplane.
5. Fasten the captive screws on the SEM.
Figure 14 Installing a SEM for an M9000-AI-E8 gateway
Installing a SEM for an M9000-AI-E16 gateway
1. Wear an ESD wrist strap and make sure the wrist strap is reliably grounded.
2. Remove the filler panel from the target SEM slot. Keep the removed filler panel secure for future
use.
13