Repackaging The Gateway; Repackaging A Power Supply; Repackaging A Card; Repackaging The Gateway Chassis - H3C SecPath M9000-AI-E8 Installation Manual

Repackaging the gateway

Repackaging a power supply

WARNING!
Before removing a power supply, switch off the circuit breakers at the input end of all power cords,
and remove all the power cords to avoid device damage and bodily injury.
To repackage a power supply:
1. Prepare the packing bag and box of the power supply. Make sure the bag is clean, dry, and not
damaged.
2. Remove all power supplies from the chassis, and then install blank filler panels to the empty
slots.
For how to remove a power supply and install a blank filler panel, see "Replacing a power
supply."
3. Put the removed power supply into the anti-static bag.
4. Place the foam cushion over the power supply.
5. Place the power supply and the foam cushion in the packing box, and seal the box with tape.

Repackaging a card

1. Prepare the original packing materials, including the anti-static shielding bag, foam cushion,
and packing box, for a card. Make sure these packing materials are clean, dry, and not
damaged.
2. Remove the transceiver modules, if any, from the card. If no transceiver module is installed on
the card, go to the next step.
For how to remove a transceiver module, see "Replacing a transceiver module."
3. Remove all cards from the chassis slots, and install blank filler panels to the empty slots.
For how to remove a card and install a blank filler panel, see "Replacing a card."
4. Put the removed card into the anti-static bag.
5. Place the foam cushion over the card.
6. Put the card and the foam cushion into the box, and seal the box with tape.

Repackaging the gateway chassis

(Optional.) Removing the air filter doors

See the user guide provided with the air filter doors to remove the air filter doors, if any.

Removing cable management brackets

Before repackaging the gateway chassis, remove the cable management brackets from the chassis.
The cable management brackets have been installed on the two sides of an M9000-AI-E8 gateway
when the gateway is shipped. You only need to attach the cable guides to the cable management
bracket.
To remove the cable management brackets from an M9000-AI-E16:
2