H3C SecPath M9000-AI-E4 Installation, Quick Start

H3C SecPath M9000-AI-E4 Multiservice Security Gateway
Installation Quick Start-6PW106
Installation tools
No installation tools are provided with the device. Prepare them yourself as required.
Wear an ESD wrist strap when installing the device. Make sure the wrist strap makes good
skin contact and is reliably grounded.
Flat-head Phillips Needle-nose Diagonal
screwdriver screwdriver pliers pliers
Installation accessories
Mounting Slide rails and M4 screw M6 screw
brackets with chassis rails
a cable
Airflow direction of the device
The device can provide front-to-back or back-to-front airflow by using different fan trays.
Make sure the device has a correct airflow direction for ventilation at the installation site.
FAN-20F-2-A fan tray
Connecting the grounding cable
•
The device has one primary grounding point and one auxiliary grounding point on the side
panel. The primary grounding point has a grounding sign and is located near the front
panel (with hard disks). In the following figure, the grounding cable is connected to the
primary grounding point.
•
Connect the grounding cable to the device before mounting the device in a rack. To avoid
affecting installation of the chassis rails, install the grounding cable and mounting brackets
at the same side.
ESD wrist
Wire stripper Crimping tool
strap
Cage nut Grounding
cable
FAN-20B-2-A fan tray
BOM: 3104A0QA
Mounting the device in a rack
•
The device provides multiple chassis rail installation positions on the side panels. Determine
the chassis rails installation position based on the rack depth and make sure the front ends
of the slide rails can reach out of the chassis rails.
•
Install the mounting brackets at the front panel side or rear panel side of the device as
required. In the following figure, the mounting brackets are installed at the front panel side.
Attaching cage nuts and slide rails to the rack
Attaching the mounting brackets
and chassis rails to the device
Mounting the device in a rack
Use M6 screws to secure the device in the rack.