Henny Penny PFE-590 Operator's Manual page 40

Henny Penny
12. After setting the alarm 3, press and release the FUNCTION button.
"FILTER" and "CYCLES" show on the left side of the display and the
filter cycle value is on the right side of the display. The value is the
number of cook cycles that must completed before the control signals
the operator that the shortening needs filtered.
在设置了警报3后，按下再释放功能按钮，"FILTER" 和"CYCLES会
在显示板的左边显示和过滤周期值显示在显示板的右边， 这个值是
在操作员需要过滤炸油之前必须完成的烹炸周期次数的控制信号。
13. After setting the filter value, press and release the SELECT FUNCTION
button. "EOC" and "EXIT" flashes on the left side of the display and
"COOL" shows on the right side of the display. The end-of-cycle,
(EOC), exit point can be set to COOL, SETP, or FITR, by pressing any
of the product buttons (EOC). At the end of a cook cycle the controls
can be set to return to Idle mode, the set point temperature, or to signal
the operator to filter the shortening.
设置好过滤值后，按下再释放功能按钮，"EOC" 和 "EXIT" 会在
显示板的左边显示和"COOL"显示在显示板的右边，（EOC代表周
期结束），EXIT处可以通过按下产品按钮可被设置成COOL, SETP
或FITR, 在一个周期结束之后，控制可以返回至设置好的空转模
式，设置点温度模式，炸油过滤模式。
14. After setting the end-of-cycle point, press and release the FUNCTION
button. "HEAD" and "COUNT" flashes on the left side of the display
and a number shows on the right side of the display. The number on
the right, is the number of head of chicken to be cooked at one time,
when that product button is pressed. The number can be changed by
pressing the appropriate product button. The control can then
accumulate the head count (usage) of that product, based on counting
the number of cook cycles.
设置好周期结束点之后，按下再释放功能按钮。"HEAD" and
"COUNT" 会在显示板的左边闪亮和一个数值显示在显示板的右
边，当产品按钮被按下时，这个数值显示的是炸锅在一个时间内
烹炸的鸡的头数。此数值可以通过按下适当的产品按钮进行改变。
这个控制可以基于烹炸周期的次数上统计某一种产品的数量。
40
Model PFE-590