Henny Penny PFE-590 Operator's Manual page 38

Henny Penny
NOTE 注 意
If no buttons are pressed, within approximately 1 minute while in the
program mode, the controls will revert back to the cook mode.
在程序模式中，如果没有任何按钮按下，一分钟后，控制器会回到烹
炸模式。
3. Press the appropriate product button, (1-0), to identify what product you
want to program.
按下适当的产品按钮（1-0），确定你要进行烹炸的产品程序。
4. "INT1" and "TIME" will flash on the left side of the display. The right
side will show the starting time of the cook cycle and can be changed by
pressing the appropriate numbers. Ex: Press 1,0,0,0 and 10:00 will flash
on the right side of the display, setting the start time at minutes.
"INT1"和"TIME"会在显示板的左边闪亮。 显示板的右边会显示烹炸开
始的时间并且可以按下适当的数字进行改变。例如：按下1，0，0，0，
然后10：00 会显示在显示板的右边，可以用分钟设置开始时间。
5. After setting the time, press and release the Function button and "INT1"
and "TEMP" will flash on the left side of the display. The right side will
show the starting temperature and can be changed by pressing the
appropriate numbers. Ex: Press 2,5,0 and "250° F" will show on the right
side of the display, setting the start temperature at 250° Fahrenheit.
设置好时间后， 按下再释放功能按钮， "INT1"和"TEMP"会在显示板的
左边闪亮。 显示板的右边会显示烹炸开始的温度并且可以按下适当的
数字进行改变。例如：按下2，5，0，然后250℉ 会显示在显示板的
右边，也就是设定启始温度在250℉。
7. After setting the temperature, press and release the Function button and
"INTI", "LOAD", and "COMP." Will flash on the left side of the display.
The factory preset load compensation value shows in the right side of the
display.
设置好温度后，按下再释放功能按钮，"INTI", "LOAD", 和"COMP"
三个按钮会在显示板的左边闪亮。 工厂预设的负荷补偿值会显示在显
示板的右边。
38
Model PFE-590