Henny Penny PFE-590 Operator's Manual page 45

Henny Penny
6. To test the blower, press and hold the 4 button.
测试吹风机，按下并保持4按钮。
7. To test the module, press and hold the 5 button.
测试模块，按下并保持5按钮。
NOTE 备 注
To test the heat output on CE units, the blower and modules must
first be turned on .
对CE的产品做热输出的测试，吹风机和摸板必须先打开。
Appliance Test
Press and hold the Function button for two seconds until "REG
PROGRAM" shows in the display. As soon as "REG PROGRAM"
shows in the display, press and release the Function button 5 times
until "APPL TEST" shows in the display.
按下保持功能按钮不放2秒钟，这时"REG PROGRAM"会显示出
来。然后，按下再释放功能按钮5次，这时显示屏上显示"APPL
TEST"。
With the power switch on, the display will show "CURR=", along
with the time it took the unit to heat from 250º to 300º F (121ºto
149º C) . This is normally recorded from the initial heat up in the
morning.
电源打开时，显示屏会显示"CURR="，随着时间的加长，热量
会从250º 到 300º F (121º 到 149º C)。这是早晨从初始温度开
始达到的正常记录。
Heat Control 热度控制
1. Press and hold the Function button for two seconds until "REG
PROGRAM" shows in the display. As soon as "REG
PROGRAM" shows in the display, press and release the Function
button 6 times until "HEAT CNTRL" shows in the display.
按下保持功能按钮不放2秒钟，这时"REG PROGRAM"会显示
出来。 然后， 按下再释放功能按钮6次， 这时显示屏上显示"HEAT
CNTRL"。
45
Model PFE-590