Henny Penny PFE-590 Operator's Manual page 46

Electric pressure fryer

Hide thumbs Also See for PFE-590:

Henny Penny

2. When "CODE" shows in the display, press 1-2-3-4. "MELT",

"EXIT", and "TEMP" will flash in the display, along with the

shortening temperature at which the unit will exit the melt cycle.

This should be set at 180º F (82º C), and should not be changed

until the factory is consulted.

当显示屏上显示"CODE"时，按下1-2-3-4， "MELT", "EXIT", 和

"TEMP" 会在显示屏上显示。同时会在炸锅退出融化循环是

炸油温度，这个被设置在180º F (82º C)，不要轻易被改变。

3. Press and release the Function button and "MELT", "CYCLE",

and "100s" shows alternately in the display, along with the period

(pulse) length of 4000. This should not be changed until the

factory is consulted.

按下并释放功能按钮，和"MELT", "CYCLE", 和 "100s"会交替

显示在显示屏上，有4000的脉冲长度。这个设置不要轻易去改

变，除非征得工厂同意。

4. Press and release the Function button twice and "MELT", "ON-",

"TIME", and "100s", shows alternately in the display, along with

the length of time the heat is on. This should be set at 1700, and

should not be changed until the factory is consulted.

按下并释放功能按钮两次， "MELT", "ON-", "TIME", 和 "100s"

会交替显示在显示屏上，100秒后，加热启动。这个设置应该设

置为1700，这个设置不要轻易去改变，除非征得工厂同意。

5. Press and release the Function button three times and "COOL",

"SET-", and "POINT" shows alternately in the display, along with

the temperature at which the control exits the melt cycle. This is

set at 250º F (121º C), and should not be changed until the factory

is consulted.

按下并释放功能按钮三次，"COOL", "SET-", 和 "POINT" 会

交替显示在显示屏上，伴随着显示控制退出熔化循环的温度。

这个应该设置为250º F (121º C)，这个设置不要轻易去改变，除

非征得工厂同意。

Model PFE-590

Table of Contents