Table of Contents
Advertisement
Chapter 2: Installing the Switch
Installing the Switch in an Equipment Rack
What to Prepare
for Installation
Installing the
Switch in an
Equipment Rack
56
The FS980M series switch can be installed in an equipment rack.
You need the following items to install the switch in an equipment rack:
One FS980M switch
One set of brackets
Screws for brackets
Screws for an equipment rack
Phillip-head screwdriver (not provided)
Cross-head screwdriver (not provided)
Note
Phillip-head and cross-head screwdrivers are not included in the
shipping box.
Installation guidelines can be found in "Choosing a Site for the Switch" on
page 47.
Here is the procedure for installing the switch in a 19-inch equipment rack.
Caution
The chassis may be heavy and awkward to lift. Allied Telesis
recommends that you get assistance when mounting the chassis in
an equipment rack. E28
1. Place all the items from the packaging on a work table.
2. Orient the brackets against the sides of the switch and secure them to
the switch with the eight screws as shown in Figure 31 on page 57.
Advertisement
Table of Contents
