Restore Se Password - Matrix SETU VGFX Quick Start Manual

http://arttel.ru

Restore SE Password

To program SETU VGFX, you must login into the JEEVES or enter programming
mode using SE password. However, if you forget SE Password it is possible to reset
the same by changing the jumper position.
To default the SE password, follow the steps given below:
• Switch Off SETU VGFX.
• Locate a mini jumper J5 on the card. It is in BC position by default.
• Change the jumper position from BC to AB.
• Switch On the system and wait till it gets initialize.
• SE password gets default to 1234.
• Switch Off SETU VGFX and restore the jumper in its original position i.e. BC.
• Switch On the system again.
• SE password gets default to 1234.
Please note that when you default SE Password by changing Jumper settings, following
parameters will also get default.
•
•
•
•
Matrix SETU VGFX Quick Start
Antenna Splitter
Ports
Network Connection Type (Static)
IP Address (192.168.001.146)
Subnet Mask (255.255.255.000)
VLAN
LEDs
75