Table of Contents
Advertisement
QB-V850MINIL, QB-V850MINI Emulator
4.2
System Configuration
This section describes the system configuration for debugging with the in-circuit method.
4.2.1
Minimum system configuration
The system configuration shown in the following figure illustrates the minimum system configuration required for
debugging with the in-circuit method. Note that items <6> and <7> in Figure 4-1 are not included with the
QB-V850MINI or QB-V850MINIL. Note also that item <5> is included with the QB-V850MINI but not with the
QB-V850MINIL.
Figure 4-1. Minimum System Configuration for Debugging with In-Circuit Method
<1> Host machine:
<2> USB cable (accessory)
<3> QB-V850MINIL or QB-V850MINI (this product)
<4> OCD cable (accessory)
<5> V850MINI Self-check board (included with the QB-V850MINI) or QB-V850ESKX1H-DA
<6> Exchange adapter (sold separately)
<7> Target connector (sold separately): A connector mounted on the target system.
R20UT0221EJ0400 Rev.4.00
2013.08.30
<2>
<1>
With USB ports
4. Debugging with In-Circuit method
<4>
<3>
<5>
<6>
<7>
Target system
Page 59 of 86
Advertisement
Table of Contents
