Specifications - Renesas QB-V850MINIL User Manual

QB-V850MINIL, QB-V850MINI Emulator
1.4

Specifications

This section describes QB-V850MINIL or QB-V850MINI hardware specifications and specifications for the debug
function when using the Integrated debugger.
Classification
<R>
QB-V850MINIL/
QB-V850MINI
main unit
<R>
Host machine
interface
<R>
Target interface
<R>
R20UT0221EJ0400 Rev.4.00
2013.08.30
Table 1-1. Hardware Specifications
Item
Operating power supply
Operating clock
Operating environment
Storage environment
External dimensions
Weight
Target host machine
Target OS
USB
USB cable length
Current consumption
Target device
OCD cable length
Clock frequency
Voltage range
Number of signals occupied for debugging
V850E2/V850E1/ V850E2S/V850E2M
V850ES signals signals
DCK TCK
DMS TMS
DDI TDI
DDO TDO
DRST# TRST#
- RDY#
Number of signals used for flash
memory writing FLMD0
Number of signals for target power
supply detection V
DD
Number of GND signal lines
GND
Number of signals for reset interface
RESET#
Note Not all hardware combinations of host machine, USB device, and USB hub are guaranteed to work.
Specifications
5 V (USB-bus powered type) 500 mA (Max.)
Clock mounted in QB-V850MINIL or QB-V850MINI
Temperature: 0 to +40°C
Humidity: 10 to 80% RH (no condensation)
Temperature: −15 to +40°C
Humidity: 10 to 80% RH (no condensation)
88.5 × 56.5 × 26.1 mm (see Appendix B External Dimensions for
details)
Approximately 90 g
TM
IBM PC/AT compatibles
Windows XP, Windows 7
1.1, 2.0
2,000 mm max.
Approximately 350 mm
Microcontroller with V850E2S, V850E2M, V850E2, V850E1,
V850ES Series on-chip debug unit and microcontroller with
Nx85ET core
200 mm
Equivalent to specifications supported by the target device
2.0 to 5.5 V
V850E2, V850E1, V850ES: 5
V850E2S, V850E2M: 6
Clock for DCU
DCU state transition control signal
Data signal transmitted to DCU
Data signal transmitted from DCU
DCU reset signal
Synchronous signals
1
Flash programming mode setting signal
1
Power supply (The power supply for buffers of a debugging
interface, or for power supply detection of a target system)
− (depends on the target connector for OCD)
GND signal
1
System reset input signal
1. Outline
Note
Page 20 of 86