Table of Contents
Advertisement
QB-V850MINIL, QB-V850MINI Emulator
3.2
Setup Procedure
This section describes QB-V850MINIL or QB-V850MINI setup procedure to operate QB-V850MINIL or
QB-V850MINI normally. Perform setup using the following procedure.
Installation of software
Install the USB driver, software tool, etc., in the host machine.
See 3.2.1 Installation of software.
Proceed to the next step if installation of software has already been completed.
Setting of switch
Set SW1.
This step is not necessary when using a connector other than the MIictor connector as the target connector.
See 3.2.2 Switch settings to perform setting in the correct order.
Connection and startup of system
Connect the host machine, QB-V850MINIL or QB-V850MINI, and target system and start the entire system.
See 3.2.3 Connection and startup of system to perform setting in the correct order.
System shutdown
Shut down the system to terminate debugging.
See 3.2.4 System shutdown.
R20UT0221EJ0400 Rev.4.00
2013.08.30
3. On-Chip Debugging
Page 29 of 86
Advertisement
Table of Contents
