Table of Contents
Advertisement
QB-V850MINIL, QB-V850MINI Emulator
Power application to target system
（3）
Apply the power to the target system. After power application, confirm that the TARGET LED on
QB-V850MINIL or QB-V850MINI is lit.
When using the QB-V850MINIL, if the yellow LED is on, it means that an overvoltage may be being applied.
Check the target system's power supply and make sure that an appropriate voltage is being applied.
Running the software
（4）
Start up and run the software as described in the supplied user's manual.
3.2.4
System shutdown
Terminate debugging and shutdown the system in the following order.
Terminate the the software tool.
（1）
Turn off the power to the target system.
（2）
Disconnect the USB cable from the host machine.
（3）
3.3
Default Setting
Item
SW1
R20UT0221EJ0400 Rev.4.00
2013.08.30
Setting
All of switches 1 to 8 are set to OFF by default.
Refer to 3.2.2 Switch settings for how to set the switches.
3. On-Chip Debugging
Description
Page 32 of 86
Advertisement
Table of Contents
