Table of Contents
Advertisement
QB-V850MINIL, QB-V850MINI Emulator
(1) SW1
Switches used for performing the initial settings for QB-V850MINIL/QB-V850MINI. They are set to OFF by
default.
Refer to 3.2.2 Switch settings for details on the settings.
(2) USB connector
A connector used for connecting the USB interface cable.
(3) OCD connector
A connector used for connecting the OCD cable.
(4) Screw
A screw used for fixing QB-V850MINIL or QB-V850MINI main unit.
(5) LED
The meanings of each LED are listed below.
Display Name
POWER
TARGET
STATUS
OVER VOLTAGE
(QB-V850MINIL only)
R20UT0221EJ0400 Rev.4.00
2013.08.30
Lit/Extinguished
Lit
The power supply to QB-V850MINIL or QB-V850MINI is on.
Extinguished
The power supply to QB-V850MINIL or QB-V850MINI is off.
Lit
The power supply to the target system is on.
Extinguished
The power supply to the target system is off, or the target system is not
connected to QB-V850MINI.
Lit
The QB-V850MINI is running.
Extinguished
The QB-V850MINI is in the break state, or the debugger is not active.
Lit
Overvoltage of 6.5 V or higher is being applied from the target system.
Extinguished
Voltage is being applied normally from the target system.
2. Names and functions of hardware
Meaning
Page 23 of 86
Advertisement
Table of Contents
