Setup; System Configuration; Hardware Setting; Terminal Software Setting - Renesas J80D1 User Manual

Voice over PLC Sample Application Operating Manual

2. Setup

2.1

System configuration

In order to communicate using the sample application, two or more
application is used by connecting J80D1 board and PC with USB Cable. In order to check the sound, it is
necessary to connect a microphone to CN14 of the sender audio board and a speaker to CN16 of the
receiver audio board.
J80D1
PC
Figure 2-1 system configuration of sample application

2.2 Hardware setting

Set the J80D1 board to use MCU (RX651).
Switches and Jumpers.
SW1
SW5
SW6
Refer to " BCPX3 Evaluation Kit J80D1 User's Manual (R30UZ0098EJ0100)" for other switch and
jumper settings, type of microphone and speaker that can be connected
board.

2.3 Terminal software setting

The sample application is controlled using terminal software.
as follows.
Setting
Baud rate
Data
Parity
Stop
Flow
Newline character
R11UM0083EJ0200 Rev.2.00
June 25, 2018
J80D1
PC
USB Cable
Setting
Turn OFF all the SWs.
MCU
USE
Value
115200bps
8bit
None
1bit
none
CR + LF
RENESAS CONFIDENTIAL
RENESAS Group CONFIDENTIAL
J80D1 boards are required.
J80D1
PC
USB Cable
and how to use the J80D1
The terminal software settings should be
2. Setup
Sample
Power Line
USB Cable
Page 2 of 9