Table of Contents
Advertisement
QB-V850MINIL, QB-V850MINI Emulator
5.2
Setup Procedure
This section describes QB-V850MINIL or QB-V850MINI setup procedure to operate QB-V850MINIL or
QB-V850MINI normally. Perform setup using the following procedure.
Installation of software
Install the USB driver, software tool, etc., in the host machine.
See 5.2.1 Installation of software.
Proceed to the next step if installation of software has already been completed.
Setting of QB-V850MINIL or QB-V850MINI
Set QB-V850MINIL or QB-V850MINI SW1 to the default setting.
See 3.3 Default Setting for the default settings of QB-V850MINIL or QB-V850MINI.
Setting of self-check board
Set the self-check board to the default setting.
See 4.4 Default Settings for the default settings of the V850MINI self-check board.
Connection and startup of system
Connect the host machine, QB-V850MINIL or QB-V850MINI, and target system and start the entire system.
See 5.2.4 Connection and startup of system to perform setting in the correct order.
System shutdown
Terminate self-testing and shut down the system.
See 5.2.5 System shutdown.
R20UT0221EJ0400 Rev.4.00
2013.08.30
5. Self-Testing
Page 71 of 86
Advertisement
Table of Contents
