Table of Contents
Advertisement
QB-V850MINIL, QB-V850MINI Emulator
3.6.2
Mictor connector
The Mictor connector is conventionally supported as a target connector for OCD that supports the high-speed trace
interface. When combining use of QB-V850MINIL or QB-V850MINI and an emulator with tracing capability sold by
Renesas Eloctronics partner company, use the Mictor connector.
When using the Mictor connector as the target connector for OCD, mount the following connector on the target system.
• 2-767004-2: 38-pin type (sold separately)
Remark
2-767004-2 is a product of Tyco Electronics AMP K.K.
The following adapter is required for connection with the emulator.
• QB-V850MINIL-AM1 (sold separately)
Remark
QB-V850MINIL-AM1 is products of Renesas Electronics Corporation
Figure 3-18, Table 3-6 and Table 3-7 show the pin assignment and the pin functions of a target connector for OCD,
respectively. Input/output is indicated as seen from the target device.
R20UT0221EJ0400 Rev.4.00
2013.08.30
Figure 3-18. Mictor Connector Pin Assignment Diagram
3. On-Chip Debugging
Target system
Target system
Page 47 of 86
Advertisement
Table of Contents
