Table of Contents
Advertisement
QB-V850MINIL, QB-V850MINI Emulator
3.2.1
Installation of software
Install the following software tool in the host machine before setting up the hardware. Refer to the "Setup manual"
supplied with QB-V850MINIL or QB-V850MINI for the procedures.
• USB driver
• Debugger
• Device file
3.2.2
Switch settings
Set SW1. SW1 is mounted inside QB-V850MINIL or QB-V850MINI main unit. Loosen the screw, open the cover,
and then set SW1.
Change the SW1 setting only when all the following conditions are satisfied; otherwise, use QB-V850MINIL or
QB-V850MINI with the default setting (all "OFF").
• A Mictor connector is used as the target connector.
• Renesas Electronics partner company's emulator that supports the trace interface is used together with
QB-V850MINIL or QB-V850MINI.
• Pin 20 of the Mictor connector is used as TRCCE (trace compression enable input).
When all the above conditions are satisfied, set SW1 as follows.
SW1 Number
1 to 7
8
R20UT0221EJ0400 Rev.4.00
2013.08.30
Table 3-1. SW1 Setting (When Conditions Are Satisfied)
Setting
OFF
Default setting. Any other settings are prohibited.
ON
Setting to turn off the power supply to the self-check board
3. On-Chip Debugging
Remark
Page 30 of 86
Advertisement
Table of Contents
