Table of Contents
Advertisement
QB-V850MINIL, QB-V850MINI Emulator
3.6
Target Connectors for OCD
A target connector for OCD must be mounted on the target system in order to connect QB-V850MINIL or
QB-V850MINI to the target system. The target connector for OCD can be selected from the target connectors listed in
the table below. The features of each target connector are described in the following sections.
Table 3-4. List of Target Connectors for OCD (Part Number and Manufacturer)
Target Connector Name
KEL connector (cannot be used
when using V850E2S or V850E2M)
Adapter
Mictor connector
Adapter
SICA connector
Adapter
2.54 mm pitch 16-pin general-
purpose connector (cannot be used
when using V850E2, V850E1, or
V850ES)
Adapter
2.54 mm pitch 20-pin general-
purpose connector
Adapter
R20UT0221EJ0400 Rev.4.00
2013.08.30
Part Number
8830E-026-170S (included with QB-V850MINI)
8830E-026-170L
QB-V850MINIL-AK1 (included with QB-V850MINI)
2-767004-2
QB-V850MINIL-AM1
SICA2P20S05 (5 set)
SICA2012P (included with SICA2P20S)
HIF3FC-16PA-2.54DS
HIF3FC-16PA-2.54DSA
QB-V850MINIL-AG1 (inclued with QB-V850MINIL)
HIF3FC-20PA-2.54DS
HIF3FC-20PA-2.54DSA
Not required
3. On-Chip Debugging
Manufacturer
KEL Corporation
Renesas Electronics Corporation
Tyco Electronics AMP K.K.
Renesas Electronics Corporation
Tokyo Eletech Corporation
Tokyo Eletech Corporation
Hirose Electronic Co., Ltd.
(for example)
Renesas Electronics Corporation
Hirose Electronic Co., Ltd.
(for example)
−
Page 44 of 86
Advertisement
Table of Contents
