Table of Contents
Advertisement
QB-V850MINIL, QB-V850MINI Emulator
5.2.1
Installation of software
Install the following software in the host machine before setting up the hardware. Refer to the "Setup manual"
supplied with the QB-V850MINI for the procedures.
When using the ID850QB,MULTI(made by Green hills software Co., Ltd).,
The required device file is shown below. This file differs depending on which self-check board is being used. A device
file does not have to be installed when using CubeSuite+.
• V850MINIL self-check board: DF703736
• V850MINI self-check board: DF703318
The device file can be downloaded from the following website:
http://www.renesas.com/ghs_debug_if
5.2.2
Setting of QB-V850MINIL or QB-V850MINI
Set QB-V850MINIL or QB-V850MINI to the default setting when performing self-testing.
See 3.3 Default Setting for the default settings of QB-V850MINIL or QB-V850MINI.
5.2.3
Setting of self-check board
Set the self-check board to the default setting when performing self-testing.
See 4.4 Default Settings (V850MINI Self-check board) for the default settings.
5.2.4
Connection and startup of system
Connect and start the system in the following order.
(1) Connecting QB-V850MINIL or QB-V850MINI to self-check board
Connect QB-V850MINIL or QB-V850MINI to the V850MINI self-check board using the OCD cable.
Caution Do not connect QB-V850MINIL or QB-V850MINI to the host machine at this time.
Figure 5-2. Connecting QB-V850MINIL or QB-V850MINI to Self-Check Board
R20UT0221EJ0400 Rev.4.00
2013.08.30
5. Self-Testing
Page 72 of 86
Advertisement
Table of Contents
