Debugging With In-Circuit Method; Target Devices - Renesas QB-V850MINIL User Manual

QB-V850MINIL, QB-V850MINI Emulator
4.

Debugging with in-circuit method

This chapter describes how to use QB-V850MINIL or QB-V850MINI for debugging with the in-circuit method.
In the in-circuit method, an emulator is connected in the position where the device is to be mounted.
By using the V850MINI self-check board included with the QB-V850MINI or the separately sold
QB-V850ESKX1H-DA, QB-V850MINIL or QB-V850MINI can be used to debug the target devices shown in 4.1
below. Note that the V850MINIL self-check board included with the QB-V850MINIL cannot be used for in-circuit
emulation.
4.1

Target Devices

Debugging with the in-circuit method can be performed using QB-V850MINIL or QB-V850MINI for the following
target devices.
V850ES/KE1+, V850ES/KF1+, V850ES/KG1+, V850ES/KJ1+
Note
V850ES/KE1
Note One caution applies to debugging using the V850MINI self-check board included with the QB-V850MINI. See
No. 23 in Table 6-1 for details.
This caution item is not applicable when using the QB-V850ESKX1-DA (sold separately).
Refer to the technical document for the QB-V850ESKX1-DA (ZUD-CD-04-0120) for details.
Contact your local distributor for how to obtain this document.
R20UT0221EJ0400 Rev.4.00
2013.08.30
Note
, V850ES/KF1 , V850ES/KG1
4. Debugging with In-Circuit method
Note Note
, V850ES/KJ1
Page 58 of 86