Table of Contents
Advertisement
QB-V850MINIL, QB-V850MINI Emulator
(2) Connecting QB-V850MINIL or QB-V850MINI to host machine
Connect QB-V850MINIL or QB-V850MINI to the host machine using the USB interface cable. After performing
this connection, confirm that LEDs (POWER and TARGET) on QB-V850MINIL or QB-V850MINI are lit.
<R>
(3) Startup of V850 JTAG OCD Checker
V850 JTAG OCD Checker can be started up by clicking Start menu.
Refer to the following table for the settings to be specified in the main dialog box.
After specifying these settings, proceed according to the instructions in the V850 JTAG OCD Checker user's manual.
When using
V850MINIL
self-check
board
When using
V850MINI
self-check
board
5.2.5
System shutdown
Terminate self-testing and shutdown the system in the following order.
(1) Terminate the V850 JTAG OCD Checker.
(2) Disconnect the USB cable from the host machine.
Caution
If the above order is not observed, QB-V850MINIL or QB-V850MINI or the self-check board may be damaged.
R20UT0221EJ0400 Rev.4.00
2013.08.30
Figure 5-3. Connecting QB-V850MINIL or QB-V850MINI to Host Machine
Device file: Specify DF3736.800
Clock: Select 5.000 for Main OSC.
Internal ROM Sequrity: Select the ID code check box and input the security code specified at
addresses 0x70 to 0x79.
Emulator: Select IE-V850E1-CD-NW/QB-V850MINI (DCK=20 MHz).
Device file: Specify DF3318Y.800
Clock: Select 8.000 for Main OSC.
Internal ROM Sequrity: Select the ID code check box and input the security code specified at
addresses 0x70 to 0x79.
Emulator: At shipment, the debugger can be activated by inputting
"FFFFFFFFFFFFFFFFFFFF".Select IE-V850E1-CD-NW/QB-V850MINI (DCK=10 MHz).
5. Self-Testing
Page 73 of 86
Advertisement
Table of Contents
