Table of Contents
Advertisement
QB-V850MINIL, QB-V850MINI Emulator
Power application to target system
（3）
Apply the power to the target system. After power application, confirm that the TARGET LED on
QB-V850MINIL or QB-V850MINI is lit.
Running the software
（4）
Start up and run the software as described in the supplied user's manual.
4.3.7
System shutdown
Terminate debugging and shutdown the system in the following order.
(1) Terminate the software.
(2) Turn off the power to the target system.
(3) Disconnect the USB cable from the host machine.
Caution If the above order is not observed, QB-V850MINIL or QB-V850MINI or the self-check board may be
damaged.
4.4
Default Settings (V850MINI Self-check board)
Item
Setting
OSC1
OSC2
Adapter
SW1
Self Check
R20UT0221EJ0400 Rev.4.00
2013.08.30
Table 4-3. Default Settings of Self-Check Board
An 8 MHz resonator is mounted at shipment.
There is no need to change the setting when using an 8 MHz resonator as is.
When changing the setting, refer to 4.3.3 Clock settings for details.
A 32.768 kHz resonator is mounted at shipment.
Do not change the frequency.
SW1 is set to "Self Check" by default.
Refer to 4.3.4 Switch settings for how to set the switches.
4. Debugging with In-Circuit method
Description
Page 67 of 86
Advertisement
Table of Contents
