Moving The Equipment - Ingeteam Ingecon Sun 250 TL Installation Manual

Ingeteam Energy, S.A.
• Plastic (polystyrene, bag and bubble wrap): the appropriate container.
• Cardboard: the appropriate container.

3.4. Moving the equipment

Appropriate transport and storage of the unit are the necessary first steps for correct use and operation. Taking the
above section into account and as a preventive measure, Ingeteam Energy S.A. recommends the use of transport
companies specialised in the transport of special and/or fragile equipment.
The unit must be protected, during transport and storage, from mechanical knocks, vibrations, water splashes (rain)
and any other product or situation which may damage it or alter its behaviour.
Failure to observe these instructions may lead to loss of warranty on the product, for which Ingeteam Energy S.A. is
not responsible.
If the equipment has to be moved, be aware that the centre of gravity of these units is at the centre of its vertical
projection and at 1/3 of its height.
Transport using goods vehicles
Ingecon Sun Power Max units transported in vehicles must be kept in an upright position and properly secured in
®
accordance with its weight and size to avoid tipping and bumps.
Transport using a forklift truck
At least the following requirements should be observed:
1. Place the packaged unit centred with respect to the forks.
2. Try to locate it as close as possible to the connection between the forks and the chassis.
3. Ensure that the forks are perfectly level to avoid overturning the unit.
4. In any case, observe the instructions in the forklift truck's user manual.
Moving by crane.
When lifting by crane, the lifting eyes fitted to the top corners of the cabinet should be used, as shown below.
22
Installation manual
AAV2000IKI01