Safety Instructions; Symbols; General Safety Precautions - Ingeteam Ingecon Sun 250 TL Installation Manual

Ingeteam Energy, S.A.

4. Safety instructions

This section contains safety instructions which must be followed when installing, operating and accessing the unit.
Failure to comply with the "Safety instructions" may cause injury or even death or cause damage to the unit.
Read the "Safety instructions" carefully before working on the unit.

4.1. Symbols

The warnings advise of conditions which may cause serious injury or death and/or damage to the equipment. The
means of avoiding the hazard to both people and the unit is indicated along with the warning.
The symbols and an explanation of their meaning can be seen below.
DANGER: High voltage
Warning of high voltage: Warns of high voltage which can cause injury or even death and/or damage
to the equipment
General warning. Warns of conditions which can cause injury and/or damage to the equipment.
PRECAUTION: Hot surface
Warns of the existence of hot parts which may cause serious burns.
The specific safety warnings and notes which affect specific tasks are included in each affected chapter and are
repeated and completed within each chapter in the corresponding critical points.
Please read this information carefully as it is written for your personal safety and to ensure the longest possible service
life for the unit and the devices to which it is connected.

4.2. General safety precautions

Installation, start-up, inspection and maintenance operations may only be carried out by personnel
appropriately qualified and trained in electrical subjects (hereinafter qualified personnel). You are
reminded of the obligation to comply with safety regulations applicable to electrical work.
The fact that the various compartment housings are open in no way implies the absence of voltage.
Only qualified personnel following the safety guidelines described in this document may access the
compartments.
The set of conditions listed below should be considered as minimum requirements. It is always
preferable to shut off the main power supply. Installation defects may result in unwanted feedback.
Danger of electric shock.
In addition to the safety measures indicated in this manual, the general measures that apply in this
area (specific to the installation, country, etc) must be taken into account.
26
Installation manual
AAV2000IKI01