Handling And Unpacking; Moving The Equipment - Ingeteam Ingecon Sun Power Series Installation Manual

Installation manual
Identifying the unit
The serial number of the equipment is its unique identifier. This number must be quoted in any communication with
Ingeteam.
There is another ratings plate in a visible internal location.
Transport damage
If the equipment has been damaged during transport, proceed as follows:
1. Do not proceed with the installation.
2. Notify the distributor immediately within 5 days of receipt of the equipment.
If ultimately the unit has to be returned to the manufacturer, you must use the same original packaging.

3.3. Handling and unpacking

Correct handling of the units is vitally important in order to:
• Prevent damage to the packaging which enables them to be kept in optimum condition from shipping until
they are unpacked.
• Avoid knocks and/or falls which may harm their mechanical characteristics, e.g. cause incorrect closure of
doors, loss of IP rating, etc.
• Avoid, as far as possible, vibrations which may cause subsequent malfunction.
If you observe any anomaly, please contact Ingeteam immediately.
Recycling the Packaging
All the packaging can be delivered to a non-hazardous waste management company.
In any event, each part of the packaging may be recycled as follows:
• Plastic (polystyrene, bag and bubble wrap): the appropriate container.
• Cardboard: the appropriate container.

3.4. Moving the equipment

Appropriate transport and storage of the unit are the necessary first steps for correct use and operation. Taking the
above section into account and as a preventive measure, Ingeteam recommends the use of transport companies
specialised in the transport of special and/or fragile equipment.
The unit must be protected, during transport and storage, from mechanical knocks, vibrations, water splashes (rain)
and any other product or situation which may damage it or alter its behaviour.
Failure to observe these instructions may lead to loss of warranty on the product, for which Ingeteam is not responsible.
AAS2000IKI01
Ingecon Sun 100
®
Pac 100 kW
Uac 3 x 400 Vac
S/N: 100080102R50
Std:
Location of the unit's external ratings plate
Ingeteam Power Technology, S.A.
A
vda. Ciudad de la Innovación, 13
31621 Sarriguren (Navarra)
solar.energy@ingeteam.com
Tel 948 288000
Fax 948 288001
IP20 2011
Udc: 405-900 Vdc
Fac: 50/60 Hz
15