Table of Contents
Advertisement
Section 2
Operation
Platform Stalled
Platform Stalled alerts the operator that
free platform movement is inhibited.
The motor will automatically shut off and attempt to restart after
approximately 15 seconds. In the alarm state, the audible alarm is muted
by pressing the Silence button but will ring back in about 15 minutes.
However, the alarm messages and indicator lights will persist until the
fault is corrected. The motor will continue to cycle on and off until the
obstruction is removed, or the unit is turned off. On motor restart, the
audible alarm and indicator lights are automatically cleared, but the alarm
messages will remain until cleared by pressing the Silence button.
Caution Turn off unit power when removing any platform obstruction to
s
prevent possible injury.
Check Fuse
Check Fuse alerts the operator that there
is no communication with the motor
drive circuit board (historically the
primary drive motor fuse has blown). In the alarm state, the audible alarm
is muted by pressing the Silence button, but will ring back in about 30
minutes. However, the alarm messages and indicator lights persist until the
fault is corrected. When the unit is turned on after fuse replacement, all
alarm indicators are automatically cleared.
Warning Fuse replacement must be performed by qualified service
s
personnel. See Service section.
Change Configuration
To access the system Configuration menu, press the down arrow, the up
arrow, then the Silence button, in that order. This screen will appear.
Pressing the down arrow
continues system configuration.
Pressing the up arrow returns to the Operating Screen.
Thermo Scientific
MaxQ SHKE8000 Series Shakers
2-11
Advertisement
Table of Contents
