Table of Contents
Advertisement
(continued)
Software Version
Thermo Scientific
Heat %
Main Heat % is the percentage of time that the chamber heater is turned
on during a five second period. Example: If the
heater is being cycled on for two seconds and off
for three seconds, the Heat % value is 40 percent.
Door Heat % is the percentage of time that the door glass heater is
operating during a five second period (Model SHKE8000-7 &
SHKE8000-8CE).
When finished, press any of the three buttons (Time, Speed, or Temp) to
save the new setpoint value and return to the previous screen, or press
nothing for about 15 seconds to save the new setpoint value and return to
the Operating Screen.
Software Version is for factory use only and will be important if
troubleshooting the microprocessor programming is ever necessary. To
view this information, open the Configuration menu by pressing the down
arrow, up arrow, and the Silence button, and then the down arrow four
times, in the sequence shown below.
The screen at right will appear on
the display.
Press the Time button beneath
SwVers and the next screen will
appear, showing the appropriate MaxQ
SHKE8000 Series software version in the
control system memory, where X is the release
level and y is the revision level.
When finished, press any of the three buttons (Time, Speed, or Temp) to
save new setpoint value and return to previous screen, or press nothing for
about 15 seconds to save new setpoint value and return to Operating
Screen.
Section 2
Main:
XXX.X %
s
Door:
XXX.X %
Software Version #
443 / 444 / 445 REL X.XX
SHKE8000 & SHKE8000-1CE
Software Version #
493 / 495 / 496 REL X.XX
SHKE8000-7 & SHKE8000-8CE
MaxQ SHKE8000 Series Shakers
Operation
2-19
Advertisement
Table of Contents
