Table of Contents
Advertisement
Section 1
Installation
Location
Positioning
1-2
MaxQ SHKE8000 Series Shakers
Locate the shaker on a firm, level surface in an area free of dust and dirt.
To allow for service access, the back of the shaker must be at least 4 inches
from the wall. Note location of the power and light switches (Figure 1-1).
As the electrical plug is the mains disconnect for the unit, the electrical
wall outlet must be easily accessible at all times.
Warning Use extreme caution when lifting and positioning these units.
Model SHKE8000 & SHKE8000-1CE each weigh 550 lbs (249.5kg) and
Model SHKE8000-7 & SHKE8000-8CE each weigh 600 lbs (272.2kg).
Warning Do not lift the unit by hand. Always use suitable equipment
designed to support over 600 lbs. (272.2kg).
Warning It is imperative that all specified installation hardware be used
when stacking shakers. Failure to do so may result in severe injury and/or
s
equipment damage.
Caution Do not lift Model SHKE8000-7 or SHKE8000-8CE under the
refrigeration assembly attached to the side of the shaker! This structure is
not designed to support the weight of the unit.
Caution Do not lift or position the unit by the door or door handle.
Damage to door mounting and gasket may occur.
Caution Do not lift with forklift or other lifting device near the center of
the unit base. Damage to the shaker mechanism mounting may occur.
When lifting from the base, position the lifting device as close as possible
to the leveling feet. Whenever
possible, lift the unit by the
four threaded inserts (Figure
1-2). Do not attempt to lift a
stack of units by the threaded
inserts. The inserts are
provided to lift and position
only one unit at a time.
s
s
Figure 1-2. Exterior Top of Unit
s
s
Threaded inserts
5/16"-18
Thermo Scientific
s
Advertisement
Table of Contents
