Table of Contents
Advertisement
Section 1
Installation
Chamber Drain
Condensate Drain
Assemble Flask Clips
1-10
MaxQ SHKE8000 Series Shakers
A drain is provided in the bottom of the chamber for convenience when
cleaning or removing spills (Figure 1-22). A clear vinyl hose and plastic
valve are connected to the drain and accessed by removing the lower front
panel. The panel has two screws along the bottom and tabs along the top
located in slots.
Figure 1-22. Chamber Drain
A 3/8" O.D. stainless steel condensate drain is located on the right side of
the shaker in the side car (refrigerated models only). This drain removes
any water which may collect in the air ductwork. Water accumulates into a
pan where it is evaporated by the heat from the refrigeration system. This
drain does not require maintenance.
Each flask clip up to 2.8 liters in size comes with a metal spring which
must be installed onto the clip. For flask clips through 500 ml, insert the
end of each spring into the holes on the top of the clip leg as shown in
Figure 1-23.
Figure 1-23. Clip Assembly
Figure 1-24. For Liter or Larger Flasks
Thermo Scientific
Advertisement
Table of Contents
